deflections

英 [dɪˈflɛkʃənz]

美

n.  (尤指击中某物后)突然转向，偏斜，偏离
deflection的复数

柯林斯词典

• N-VAR 偏斜;偏转
  Thedeflectionof something means making it change direction.
  1. ...the deflection of light as it passes through the slits in the grating.
     光线通过光栅狭缝时的偏转
• (体育运动中球击中某物后的)转向，变向
  In sport, thedeflectionof a ball, kick, or shot is when the ball hits an object and then travels in a different direction.

双语例句

• And on the right, you notice that there are many of those sharp deflections.
  在右侧，大家看到，有很多明显的变位。
• Experimental results indicate that the cracks weaken the strength of slabs, lower their stiffness, and induce the deflections of slabs beyond limit.
  试验结果表明，支座边的裂缝严重削弱了板的承载力，降低了楼板的刚度，导致楼板的挠度过大。
• However, while some building codes provide methods for estimating shear wall deflections, these methods are not adequate for shear walls without hold-downs.
  尽管有些国家的建筑规范中已给出了估算木结构剪力墙侧向变形的方法，但这些方法并不适用于无抗倾覆锚固件木结构剪力墙。
• This renders the bearing like other self-aligning bearings, impervious to misalignments and shaft deflections.
  有这种装置的轴承就像自调整轴承，可以避免误差和轴倾斜。
• The test results showed that the fracture deflections of the composite coatings and the fractal dimensions of the fractured surfaces decreased with increasing the contents of hard phases.
  测量了多相材料复合涂层的断裂挠度和断口表面的分形维数，分析了复合涂层的断裂特征结果表明：随着硬质相增加，复合涂层的断裂挠度和断口表面的分形维数降。
• The structural analysis is based on a quadrilateral flat-shell element and an updated Lagrange ( UL) formulation, which can be employed to model geometric nonlinearities arising from large deflections.
  结构部分以四边形平板壳元为基础，采用更新的拉格朗日（UL）方法分析结构大变形引起的几何非线性问题。
• The deflections of throttle slices were analyzed and the equivalent relations of flux distribution were deduced according to the structure of self-designed hydro-pneumatic spring.
  根据自主研发阻尼可调油气弹簧的结构形式，分析了叠加节流阀片的挠曲变形量，给出系统流量分配的等效关系。
• The deflections of the vertical happen to be known in this case ( see below).
  垂直偏斜碰巧在此例中有证明（看下图）。
• Where required, to examine deflections, stiffness requirements, and any special material and design provisions to obviate brittle fracture under adverse conditions.
  必要时验算挠度、刚度要求、以及任一特殊材料和设计规定，以预防不利条件下的脆断。
• We may use the plane stress analysis for determining deflections in the midplane of the beam.
  我们可以用平面压力的分析方法来确立梁中间面的挠度。